Publicité
Les langues disponibles
Les langues disponibles
4. Screw the spray tip and tip guard onto the pistol and manually tighten.
Operation
Spray
1. Disengage the trigger lock.
2. Make sure that the arrow-shaped nozzle is pointing to the front (for spraying).
3. Hold the spray gun vertically approx. 25 - 30 cm away from the surface of the work-
piece. First move the gun and then actuate the trigger to spray a test pattern. Begin at a
low pressure.
4. Slowly increase the pump pressure until a consistent spray pattern is produced (the
sprayer's operating manual contains further information about this).
Align spray jet
1. Follow pressure relief procedure.
2. Loosen tip guard retaining nut.
3. Align the tip guard horizontally to spray a horizontal pattern.
4. Align the tip guard vertically to spray a vertical pattern.
5. Tighten the tip guard securing nut.
Original instruction
64
Publicité
