Storch Airless Gun 009 ST Traduction Des Instructions D'origine page 60

EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
• Always wear appropriate gloves, eye protection, and a respirator or mask
when painting.
• Do not operate or spray near children. Keep children away from equipment at
all times.
• Do not overreach or stand on an unstable support. Keep effective footing and
balance at all times.
• Stay alert and watch what you are doing.
• Do not operate the unit when suffering from fatigue or under the influence of
drugs or alcohol.
• Do not kink or over-bend the hose.
• Do not expose the hose to temperatures or to pressures in excess of those
specified by STORCH.
• Do not use the hose as a strength member to pull or lift the equipment.
• Do not spray with a hose shorter than 24.5 feet.
• Do not alter or modify equipment. Alterations or modifications may void
agency approvals and create safety hazards.
• Make sure all equipment is rated and approved for the environment in which
you are using it.
PRESSURIZED ALUMINIUM PARTS HAZARD
Use of fluids that are incompatible with aluminium in pressurized equipment
can cause serious chemical reaction and equipment rupture. Failure to follow
this warning can result in death, serious injury, or property damage.
• Do not use 1,1,1-trichloroethane, methylene chloride, other halogenated
hydrocarbon solvents or fluids containing such solvents.
• Do not use chlorine bleach.
• Many other fluids may contain chemicals that can react with aluminium.
Contact your material supplier for compatibility.
PERSONAL PROTECTIVE EQUIPMENT
Wear appropriate protective equipment when in the work area to help prevent
serious injury, including eye injury, hearing loss, inhalation of toxic fumes, and
burns. This protective equipment includes but is not limited to:
• Protective eyewear, and hearing protection.
• Respirators, protective clothing, and gloves as recommended by the fluid and
solvent manufacturer.
Technical Data
Permissible material operating pressure 248 bar
Size of nozzle opening
Weight
Inlet opening
Maximum material temperature
Wetted parts
stainless steel, polyurethane, nylon, aluminium, tungsten carbide, solvent-resistant,
elastomers, brass
Noise level*
- Sound power
- Sound pressure
*Measured at 1 m distance during spraying material with water at relative thickness of
1.36 through a nozzle 517 at 207 bar corresponding with ISO 3744.
No responsibility is accepted for the accuracy of this information. Subject to technical
modifications and errors!
Original instruction
3.18 mm
163 g
1/4 npsm swivel
49° C
87 dBa
78 dBa
60