Publicité
Les langues disponibles
Les langues disponibles
The saw blade experiences difficulties
penetrating the material to be processed or the
sawing performance is insufficient:
•
Check the set stroke rate; it must be suitable
for both the saw blade and the material.
•
To select a higher stroke rate, turn up the
setting wheel for stroke rate selection.
•
Check whether the pendulum action setting is
suitable for the material to be processed.
•
If the saw blade is worn, replace it with a
new one.
•
Check whether the chosen saw blade is
suitable for the material to be processed.
The device becomes hot:
•
Make sure not to exert too much pressure on
the device during sawing.
•
To select a low stroke rate, turn down the
setting wheel for stroke rate selection.
•
Check whether the chosen saw blade is
suitable for the task to be carried out.
•
Keep the venting slots clear to prevent the
motor from overheating.
Info
Wait for at least 10 minutes before
switching the device back on.
The device still does not operate correctly after
these checks:
Please contact the customer service. If necessary,
bring the device to an authorised specialist
electrical company or to Trotec for repair.
EN
Maintenance
Activities required before starting
maintenance
•
•
•
Notes on maintenance
Inside the device, there are no parts that need to be
maintained or lubricated by the user.
Cleaning
The device should be cleaned before and after each
use.
•
850W pendulum action jigsaw PJSS 11-230V
Warning of electrical voltage
Do not touch the mains plug with wet or
damp hands.
Switch off the device.
Hold onto the mains plug while pulling the
power cable out of the mains socket.
Allow the device to cool down completely.
Warning of electrical voltage
Maintenance tasks which require the
housing to be opened must only be
carried out by authorised specialist
companies or by Trotec.
Note
The device does not have to be
lubricated after cleaning.
Warning of electrical voltage
There is a risk of a short-circuit due to
liquids penetrating the housing!
Do not immerse the device and the
accessories in water. Make sure that no
water or other liquids can enter the
housing.
Clean the device with a soft, damp and lint-
free cloth. Make sure that no moisture enters
the housing. Protect electrical components
from moisture. Do not use any aggressive
cleaning agents such as cleaning sprays,
solvents, alcohol-based or abrasive cleaners
to dampen the cloth.
43
Publicité
