Trotec PJSS 11-230V Traduction De La Notice Originale page 34

Information on noise and vibration:
• The specified total vibration and noise
emission values were measured by means
of a test procedure standardized in EN 62841
and can be consulted for the comparison of
one power tool with another.
• The specified total vibration and noise
emission values can also be used for
preliminary load assessment.
Caution
Vibration emissions can cause a health
hazard if the device is used for an
extended period of time or if it is not
properly handled and maintained.
• The actual vibration and noise emission
may differ from the stated values during
operation of the power tool. This depends on
how the power tool is used and especially on
the type of workpiece being processed. Try to
keep the vibration load to a minimum.
Exemplary measures for reducing the
vibration load include wearing gloves during
operation of the tool and the limitation of
working hours. All parts of an operating cycle
must be considered for this (e.g. times at
which the power tool is switched off and
times when it is switched on but runs without
load).
34
Transport and storage
Transport
Before transporting the device, observe the
following:
•
•
•
•
•
Storage
Before storing the device, observe the following:
•
•
•
•
•
•
When the device is not being used, observe the
following storage conditions:
•
•
•
850W pendulum action jigsaw PJSS 11-230V
Note
If you store or transport the device
improperly, the device may be damaged.
Note the information regarding transport
and storage of the device.
Switch off the device.
Hold onto the mains plug while pulling the
power cable out of the mains socket.
Allow the device to cool down.
Remove the tool from the tool holder.
If attached, disconnect the dust extraction
system from the device.
Switch off the device.
Hold onto the mains plug while pulling the
power cable out of the mains socket.
Allow the device to cool down.
Remove the tool from the tool holder.
If attached, disconnect the dust extraction
system from the device.
Clean the device as described in the
Maintenance chapter.
Dry and protected from frost and heat
Ambient temperature below 45 °C
protected from dust and direct sunlight
EN