Trotec PJSS 11-230V Traduction De La Notice Originale page 37

2. Remove the anti-splinter guard (11) from the
base plate (6) by carefully pushing the anti-
splinter guard (11) outwards.
3. To reinsert the anti-splinter guard (11),
carefully push it into the recess of the base
plate (6) from below until the anti-splinter
guard (11) locks in place. When doing so,
make sure that the smooth side of the anti-
splinter guard (11) points away from the
device.
Adjusting the cutting angle
The cutting angle can be adjusted to the left or right
at angles of 0° / 15° / 30° / 45°.
1. First, remove the anti-splinter guard (11) and
the protective cover (16).
EN
2.
6
14
11
3.
16
11
850W pendulum action jigsaw PJSS 11-230V
Push the base plate lock (14) to the front.
Slide the base plate (6) to the rear until it can
be freely rotated.
37