Publicité
Les langues disponibles
Les langues disponibles
Sawing:
•
Only use intact, flawless saw blades. Bent,
blunt or otherwise damaged saw blades
could break.
•
When sawing lightweight construction
materials, make sure to observe the legal
regulations and recommendations of the
material manufacturers.
•
Before sawing wood, chipboards, building
materials etc. with HCS blades, check the
above for foreign objects, e.g. nails, screws
or similar. If required, remove the foreign
objects or use HSS saw blades.
•
Use a narrow saw blade when sawing tight
curves.
•
The saw blade should not be longer than
required for the intended cut.
Switching the LED work light and laser on and
off
The device is equipped with an LED work light to
illuminate the workpiece and with a laser to mark
the cutting path. The laser is best suited for cuts
with a 0° cutting angle.
Warning of laser radiation
Laser class 2, P max.: < 1 mW, λ:
400-700 nm, EN 60825-1:2014
Do not look directly into the laser beam
or the opening from which it emerges.
Never point the laser beam at people,
animals or reflective surfaces. Even brief
eye contact can lead to eye damage.
Examining the laser output aperture by
use of optical instruments (e.g.
magnifying glass, magnifiers and the
like) entails the risk of eye damage.
When working with a laser of class 2,
observe the national regulations on
wearing eye protection.
40
The LED work light and laser can be switched on
and off in the following combinations:
•
•
•
•
1.
18
850W pendulum action jigsaw PJSS 11-230V
LED work light and laser on
1 x =
LED work light on, laser off
2 x =
LED work light off, laser on
3 x =
LED work light and laser off
4 x =
Press the button for laser and LED work
light (18) until the desired combination is set.
EN
Publicité
