Trotec PJSS 11-230V Traduction De La Notice Originale page 38

4. Set the desired cutting angle. The number of
degrees to be set is engraved on the base
plate (6).
5. Slide the base plate (6) back to the front until
the toothing engages.
6. Push the base plate lock (14) to the rear.
7. Check the base plate (6) for tight fit.
Info
The anti-splinter guard and the
protective cover cannot be used for mitre
cuts.
38
Mounting the rip fence
The rip fence can be fastened on both sides of the
device.
1.
15
8
2.
3.
4.
Selecting the stroke rate
The required stroke rate depends on the material
and the operating conditions and can be determined
by way of field-testing.
The setting range covers the levels 1 – 6
(0 – 3,000 rpm). You can change the preselected
stroke rate level at any time.
850W pendulum action jigsaw PJSS 11-230V
Loosen the locking screws (15) at the slot.
Make sure not to unscrew the locking screws
completely.
Slide the rip fence (8) into the slot with the
marking pointing up.
Move the rip fence (8) into the desired
position.
Tighten the locking screws (15).
EN