Télécharger Imprimer la page

Briggs & Stratton 020831-00 Manuel D'utilisation page 9

Publicité

Les langues disponibles

Les langues disponibles

4. Attach spray wand to spray gun. Tighten by hand.
Step 4: Spray Tips
1. Select desired spray tip:
Low Pressure
Black Soap
Use to apply detergent
General Rinse
Green, 25°
Siding /
Patios Decks
Driveways /
Garage Floors
2. Pull spray wand quick connect collar back, insert
spray tip and release. Tug spray tip to ensure it is
secure.
Maximum
Rinse
Red, 0°
Paint Removal /
Oil Stains / Rust
Removal
Step 5: Start Up
NOTICE Do not start engine without water supply
connected and turned on.
1. Level product before starting.
2. Turn engine switch to ON (I) position.
Choke
Lever
Fuel
Lever
3. Move fuel shut-off lever ( ) to ON ( ) position.
4. Move choke lever (
NOTICE For a warm engine, be sure choke lever is in
RUN ( ) position.
WARNING! Risk of eye injury. Spray could
splash back or propel objects, resulting in serious
injury.
• Always wear indirect vented (chemical splash) safety
goggles when using or near this product. (Safety glasses
do not provide full protection).
• Always wear protective clothing such as long-sleeved
shirts, long pants and closed-toed shoes.
WARNING! Recoil starter kickback (rapid
retraction) will pull hand and arm toward engine
faster than you can let go, which could cause
broken bones, fractures, bruises, or sprains and result in
serious injury.
5. Position yourself as shown below, grasp recoil starter
and pull slowly until you feel some resistance. Then
pull rapidly to start engine.
6. Return recoil starter slowly. Do not let rope "snap back"
against starter.
NOTICE If engine fails to start after two attempts, move
choke lever to RUN ( ) position and repeat steps 5 and 6.
) to CHOKE ( ) position.
Engine
Switch
9

Publicité

loading