VOLTCRAFT BS-600SD Notice D'emploi page 25

9. INSERTING / REPLACING BATTERIES
• Loosen the screw on the battery compartment cover using a cross-head screw driver and
remove the battery compartment cover.
• Remove the battery holder from the battery compartment (5).
• Insert four type AA batteries into the battery holder and please note the polarity details in the
shafts of the battery holder.
• Reinsert the battery holder into the battery compartment and please note the polarity details
on the upper side of the battery holder and within the battery compartment.
• Close the battery compartment again.
Change the batteries if the goose neck camera does not work properly or the LED on the
camera does not light up completely.
10. INSERT MICRO SD CARD
You must first insert a microSD card (not included) to be able to use the photo /video function.
Proceed as follows to do so:
• Open the cover on the right next to the monitor.
• Insert a microSD card into the microSD slot (12). The contacts of the card must point in the
direction of the monitor. The card must be locked into position.
• Close the cover.
25