Publicité
Les langues disponibles
Les langues disponibles
Problem
FAULT CODES
The fault codes are shown on the display of the control panel.
Fault code
Possible cause
F5
There is insufficient water supply.
F3
The water supply does not stop.
The waste water in the appliance cannot
F2
be discharged.
F8
The heater has an error.
The safety for water overflow is
F1
activated.
The temperature of the appliance is too
F7
high.
F6
The heat sensor has an error.
FE
There is an electronic error.
•
This appliance should be installed and repaired by an authorized service only to avoid any risks. The
manufacturer cannot be held not liable for damage resulting from installation or repair by unauthorized persons.
•
Only authorized technicians are allowed to repair the appliance. Make sure that original spare parts are used
when a component has to be replaced.
•
Improper repairs or using not original spare parts can cause damage and is a risk for the user.
•
You can find the contact information for the customer service on the back of this document.
•
You can order original spare parts for your model at the customer service for a minimum period of 10 years.
This period starts from the date on which the appliance became available on the market within the European
Economic Area.
52
•
English
Possible cause
There is a high level of salt in the
water.
The cap of the salt reservoir is not
closed correctly.
Any spilled salt during filling of
the salt reservoir was not cleaned
immediately.
There is a problem with the
grounding of the mains supply.
Possible solution
•
Make sure that the water tap is fully open and that
the water supply is not blocked.
•
Close the water tap, remove the water inlet hose and
clean the filter of the hose.
•
Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
•
Close the water tap.
•
Contact the Inventum-servicedienst.
•
Do a check if the drain hose is clogged.
•
Do a check if the filters are clogged.
•
Reset the program. Refer to section
program
•
Contact the Inventum-servicedienst if the fault code
keeps re-occuring.
Contact the Inventum-servicedienst.
•
Disconnect the mains plug and close the water tap.
•
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Contact the Inventum-servicedienst.
Possible solution
Adjust the level of salt consumption.
Setting the level of
Refer to section
salt consumption
.
Make sure that the cap of the salt
reservoir is closed firmly.
Make sure that you clean any spilled
salt immediately and run a full
program to prevent corrosion.
Contact an authorized electrician.
Resetting the
.
Publicité
