Inventum VVW4530AW Manuel D'utilisation page 43

CONNECTING THE APPLIANCE
1. Connect the drain hose directly to the drain hole or to the siphon. The connection must have a
minimum height of 50 cm and a maximum height of 110 cm. Refer to the figure.
2. Do not let the drain hose hang lower than the appliance. Refer to the figure.
6 Operation
PREPARING FOR OPERATION
1. Do a check if the electricity and the water supply connections of the appliance match the values indicated in the
installation instructions.
2. Remove all packaging material inside the appliance.
3. Fill the salt reservoir. Refer to section
4. Fill the rinse aid reservoir. Refer to section
FILLING THE SALT RESERVOIR
For a good result the appliance needs soft (less calcareous) water. Salt is used to soften the water and it prevents
white lime residues on your dishes and the interior of the appliance.
Caution:
Only use salt that is suitable for a dishwasher. Do not use table salt.
Note:
Fill the salt reservoir when the salt indicator on the control panel is on.
1. Remove the lower basket.
2. Turn the cap (A) of the salt reservoir counter-clockwise to remove it.
3. Fill the salt reservoir with water.
Note:
You only have to fill the salt reservoir with water before first use of the appliance.
4. Put a funnel in the opening of the salt reservoir.
5. Fill the reservoir with salt until the overflow level.
6. Install the cap of the salt reservoir.
Caution:
Remove any spilled salt immediately and run a full program to prevent corrosion of the appliance.
SETTING THE LEVEL OF SALT CONSUMPTION
The salt consumption of the appliance depends on the level of water hardness.
Set the level of salt consumption according to the information in section
consumption) .
Note:
Contact your local water company to verify the level of water hardness in your area.
Filling the salt reservoir
.
Filling the rinse aid reservoir
.
Water hardness level settings (salt
English
(Figure 6)
(Figure 7)
(Figure 8)
(Figure 9)
(Figure 10)
• 43