Publicité
Les langues disponibles
Les langues disponibles
•
When determining the place of the appliance, make sure that you choose a place where you can easily load and
unload it.
•
Do not place the appliance in a location where the room temperature can be below 0°C.
•
Place the appliance close to a water tap or drain and mains socket. Keep in mind that the connections will not be
changed when they are made.
•
Do not hold the appliance at the door or control panel to move it.
•
Caution: Make sure that the water inlet and outlet hoses do not get stuck while placing the appliance.
•
Place the appliance in a safe and level location.
•
Do not place the appliance close to a refrigerator.
•
Make sure that the appliance is level and balanced by adjusting the feet. When the appliance is placed correctly
the door opens and closes easily.
WATER CONNECTION
•
Make sure that the indoor plumbing is suitable for installing the appliance.
•
Install a filter at the water supply to avoid damage to the appliance due to contamination from the water (sand,
clay, rust, etc.).
•
Warning: Use the new water inlet hose supplied with the appliance.
•
Warning: Before making the connection, run water through the hose.
•
The appliance must be connected to the water mains using the newly supplied hose sets. Do not reuse old hose
sets.
•
Warning: Make sure that you connect the water inlet hose directly to the water tap. The pressure of
the water tap must be a minimum of 0,03 MPa and a maximum of 1 MPa. Install a pressure relief
valve if the pressure is more than 1 MPa.
•
Caution: After connecting the appliance, open the water tap completely and do a check for leaks.
•
Caution: The appliance is supplied with a double-walled aquastop. The system automatically cuts off
the water supply if the water inlet hose is leaking and the space between the walls is filled with water.
Do not cut into the aquastop and make sure that the aquastop does not get twisted or stuck.
Note: Do not use a drain hose that is longer than 4 meter. As a result, dishes can remain dirty. The
•
manufacturer will not accept responsibility.
•
Keep the mark on the appliance in mind. If the appliance is marked '25', it means that the water temperature of
the cold water can be maximum 25°C.
ELECTRICAL CONNECTION
•
Warning: Make sure that the mains plug of the appliance is connected to a grounded mains socket.
The manufacturer is not responsible for damage resulting from using the appliance with a mains
socket that is not grounded. Only an authorized electrician can install a grounded mains socket, if not
available.
•
Make sure that the voltage and the frequency values for the current correspond to the values of the rating plate.
•
Warning: The electrical system in your home must be supplied with a 10-16 Amp fuse. The appliance
is designed for connecting to 220-240 V ~50Hz.
English
•
41
Publicité
