Inventum VVW4530AW Manuel D'utilisation page 50

German hardness
Level
[dH]
5 23-31
6 32-50
RINSE AID CONSUMPTION SETTINGS
Level Number of rinse aid doses that is dispensed
1 Rinse aid not dispensed
2 1 dose
3 2 doses
4 3 doses
5 4 doses
9 Troubleshooting
GENERAL TROUBLESHOOTING PROCEDURE
1. Try to find a solution for the problem with the help of the troubleshooting table and the fault codes.
2. If you cannot find a solution for the problem, reset the appliance. Refer to section
3. If the fault code keeps re-occuring, contact the Inventum-servicedienst.
TROUBLESHOOTING TABLE
Problem
The program does not start.
The detergent reservoir contains
detergent residues.
The appliance contains water when
the program is finished.
50 • English
French hardness
[dF]
41-55
56-90
Possible cause
The mains plug is not connected.
There is a problem with the fuse.
There is no water supply.
The door of the appliance is open.
The appliance is switched off.
The water inlet hose and filters are
clogged.
The detergent reservoir is filled while
the reservoir was still damp.
The drain hose is clogged or twisted.
The filters are clogged.
The program has not finished.
British hardness [dE] Display indicator
29-39 L5
40-63 L6
Display indicator
r1
r2
r3
r4
r5
Resetting the program
Possible solution
Connect the mains plug.
Do a check on the fuse box.
Open the water tap.
Close the door.
Start the appliance. Refer to section
Starting the appliance
Make sure that the water inlet hose
and the filters are not clogged.
Make sure that you fill the detergent
reservoir when it is dry.
• Make sure that the drain hose is
not clogged.
• Make sure that the drain hose is
not twisted.
Clean the filters. Refer to section
Cleaning the filters
.
Wait until the program is finished.
A buzzer sounds five times and the
ready indicator is on when a program
is finished.
.
.