Haier HAMTSJP86MC/1 Manuel D'instructions page 31

9. Installation
9.1 Selection of installation equipment
Cut out the work surface according to the sizes shown in the drawing.
For the purpose of installation and use, a minimum of 5 cm space shall be preserved around the hole. Be sure
the thickness of the work surface is at least 30mm. Please select heat-resistant and insulated work surface
material (Wood and similar fibrous or hygroscopic material shall not be used as work surface material unless
impregnated) to avoid the electrical shock and larger deformation caused by the heat radiation from the
hotplate. As shown below:
Note: The safety distance between the sides of the hob and the inner surfaces of the worktop
should be at least 3mm.
H
D
X
B
L(mm) W(mm)
800 520
Under any circumstances, make sure the Induction cooker hob is well ventilated and the air inlet and outlet
are not blocked. Ensure the induction cooker hob is in good work state. As shown below
Note: The safety distance between the hotplate and the cupboard above the hotplate should be at
least 760 mm.
A
B
C
D
A(mm)
760
L
W
X
X
H(mm) D(mm) A(mm)
5 52 750 1
E
B(mm) C(mm)
50 min. 20 min.
EN-30
X
A
Min.3mm
B(mm) X(mm)
480 1 50 min.
D
Air intake
F
F(mm)
3 min.
E
Air exit 5mm