Publicité
Les langues disponibles
Les langues disponibles
Fault
The cleaning robot does
not start
Disposal
WARNING
This device contains Lithium-Ion rechargea-
ble batteries. The removal and proper dis-
posal of lithium-ion batteries must be
carried out in accordance with national and
state regulations.
Warranty
The warranty conditions issued by our sales company
responsible apply in all countries. We shall remedy pos-
sible malfunctions on your device within the warranty
period free of cost, provided that a material or manufac-
turing defect is the cause. In a warranty case, please
contact your dealer (with the purchase receipt) or the
next authorised customer service site.
(See overleaf for the address)
Technical data
Electrical connection
Nominal power
Nominal voltage of battery
Battery pack type
Nominal voltage of charger
Cause
Ambient temperature is below 0 °C or
above 35 °C.
Charging state is too low.
Laser distance sensor (LiDAR) is
blocked.
Collision sensor is dirty or too close to the
virtual wall.
Fall sensors are dirty.
2-in-1 dust container with water reservoir
or dust container is not installed or incor-
rectly installed.
Filter not installed or incorrectly installed. 1. Make sure that the filter is correctly in-
Filters dirty.
Wiper cloth or wiper cloth holder not or in-
correctly installed.
The cleaning robot is jammed or stuck.
The cleaning robot or one of its wheels
has no floor contact.
W
33
V
14,8
Li-ION
V
100-240
Rectification
1. Use the cleaning robot at temperatures
above 0 °C and below 35 °C.
1. Charge the cleaning robot.
1. Clean the laser distance sensor with a dry
cloth.
2. Remove obstacles blocking the laser dis-
tance sensor.
3. Move the cleaning robot to another location
and start it.
1. Remove foreign objects by carefully tap-
ping on the collision sensor.
2. Move the cleaning robot to another location
and start it.
1. Clean the fall sensors with a dry cloth.
1. Make sure that the 2-in-1 dust container
with water reservoir or the dust container is
installed and correctly latched into place,
see chapter Installing 2-in-1 dust container
with water reservoir. Installing the dust
container
stalled.
1. Clean the filter, see chapter Cleaning the
filter.
2. If the error persists, replace the filter, see
chapter Replacing the filter.
1. Ensure that the wiper cloth holder and wip-
er cloth are correctly installed, see chapter
Installing the wiper cloth holder with wiper
cloth.
1. Remove obstacles.
1. Place the cleaning robot on a flat surface.
Rated current charger
Battery capacity
Rechargeable battery nominal ca-
pacity
Operating time when battery is ful-
ly charged in normal operation
Wireless connections
Frequency
Max. signal strength, WLAN
Filling quantities 2-in-1 dust container with water
reservoir
Dry dirt
Liquid
Dust container filling quantity
Dry dirt
Dimensions and weights of cleaning robot
Weight
English
A
0,6
mAh
3000
mAh
3200
min
120
IEEE
802.11b/
g/n 2.4
GHz
MHz
2400-
2483.5
dBm
<20
ml
300
ml
170
ml
500
kg
3,7
25
Publicité
