Kärcher RCV 3 Mode D'emploi page 23

a Fit the brush bearing.
b Fit the brush.
c Fit the brush cover and press it down until it audi-
bly latches into place.
Cleaning the side brush
1. Remove the side brush.
Illustration V
2. Clean the side brush.
3. Install the side brush.
Illustration B
Cleaning the fall sensors
Clean the fall sensors monthly.
Illustration W
1. Wipe the fall sensors with a soft cloth.
Replacing components
Replacing the filter
We recommend replacing the filter after 3 to 6 months.
1. Press any button.
The cleaning robot stops.
2. Remove the 2-in-1 dust container with water reser-
voir or the dust container, see chapter Removing
the 2-in-1 dust container with water reservoir or Re-
moving the dust container.
3. Remove the filter.
Illustration R
a Open the filter flap.
b Remove the filter flap.
c Remove the filter.
4. Install the new filter.
Illustration S
a Fit the filter.
b Fit the filter flap.
c Close the filter flap.
5. Install the 2-in-1 dust container with water reservoir
or the dust container, see chapter Installing 2-in-1
dust container with water reservoir or Installing the
dust container.
Malfunctions often have simple causes that you can
remedy yourself using the following overview. When in
Fault
Battery does not charge Charging contacts are dirty.
Troubleshooting guide
Cause
Ambient temperature below 0 °C or
above 35 °C.
6. Press the On/Off button.
Cleaning continues.
We recommend replacing the brush after 6 to 12
months.
1. Remove the brush.
Illustration T
a Press the clamps together.
b Remove the brush cover.
c Remove the brush.
d Remove the brush bearing.
2. Install the new brush.
Illustration U
a Fit the brush bearing.
b Fit the brush.
c Fit the brush cover and press it down until it audi-
bly latches into place.
Replacing the side brush
We recommend replacing the side brush after 3 to
6 months.
Note
To avoid damage, do not place the robot on the laser
sensor (LiDAR).
1. Turn the cleaning robot upside down.
2. Remove the side brush.
Illustration V
3. Install the new side brush.
Illustration B
Replacing the rechargeable battery
The rechargeable battery has reached the end of its life
if the cleaning robot constantly drives to the station for
charging after a short cleaning operation.
1. Switch off the cleaning robot, see chapter Switching
off the cleaning robot.
2. Send the cleaning robot to the Customer Service.
Observe the regulations for shipping lithium-ion bat-
teries, see Chapter Transport.
doubt, or in the case of malfunctions not mentioned
here, please contact your authorised Customer Service.
Rectification
1. Wipe the charging contacts on both the
charging station and the cleaning robot
with a dry cloth.
1. Use the cleaning robot at temperatures
above 0 °C and below 35 °C.
English
Replacing the brush
23