EUROM Heat-Duct-Pro 3 Manuel D'utilisation page 20

Control panel for HEAT-DUCT-PRO 3:
Control panel for HEAT-DUCT-PRO 9:
Location and Connection
 Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
 Mount the grip as shown in the illustration.
1 = screw M5x22
2 = Spring washer Ø5
3 = washer Ø5 x 10

Choose a suitable location for the heater, i.e.
at least one metre away from any obstructions,
walls or inflammable materials (see also safety
instructions). Always ensure that the heater has sufficient space at the back to
suck in air and at the front, to blow out hot air.
The control panel for the
HEAT-DUCT-PRO 3 has
two buttons:
 On the left the freely
 On the right the control
O = off
X
= ventilate only
X ■
= ventilate and heat (3000W)
The control panel for the
HEAT-DUCT-PRO 9 has
two buttons:
 Left
 On the right the control
O = off
X
= ventilate only
X □
= ventilate and heat (4500W)
X ■
= ventilate and heat (9000W)
20
adjustable thermostat
knob
knob with three
settings
the freely
adjustable thermostat
knob
knob with four settings