EUROM Heat-Duct-Pro 3 Manuel D'utilisation page 17

Technical data
Type
Supply voltage
Maximum capacity
Settings
Air flow
Protection class
Electrical cable
Plug
Dimensions
Weight
General safety instructions
1. Before using the machine, carefully read this entire instruction manual. Keep this
booklet in a safe place for reference.
2. Before using your new heater, check it, including cord and plug, for any visible
damage. Do not use a damaged heater, but send it back to your dealer for
replacement.
3. This heater is exclusively intended to heat workspaces such as workshops,
garages and storage spaces. Use the appliance for this purpose only.
4. Under the terms and conditions described in this leaflet, the heater can be used in
wet or damp indoor spaces such as bathrooms and laundry rooms. Do not place
the heater in the vicinity of taps, bathtub, shower, pool, fountains or other sources
of moisture. Make sure it cannot fall into water and prevent water from getting into
the heater itself. If, at any time, the heater does fall into water, unplug it
immediately! Do not use a heater that has a damp interior but have it repaired.
Never immerse the heater, cord or plug in water and never touch it with wet
hands.
5. The supply voltage and utility frequency, specified on the machine, need to match
those of the socket that is used. The electrical installation needs to be protected
by a residual current device (max. 30 mAmp).
6. Fully extend the cord before plugging in the heater. Make sure it does not come
into contact with any part of the heater and prevent it from heating up any other
way. Do not run the cord underneath carpeting; do not cover it with mats, carpet
strips, or similar and make sure it is not placed in any passageways. Make sure
the cord cannot be stepped on and that no furniture is placed on top of it. Do not
lead the cord around sharp corners and do not roll it up too tightly after use! Do
not rotate or kink the cable and do not wind it around the stove as this can
damage the insulation! Be carefull! Some parts of this product can become very
hot and cause burns. Particular attention has to be given where children and
vulnerable people are present. do not let bare skin come into contact with hot
English
Heat-Duct-Pro 3
V / Hz 220-240 / 50
W 3000
W 0 - 3000
m³/h 389
IP24
H05RN-F 3G1.0mm²,
150cm.
Schuko
cm 36,5 x 26,5 x 37
kg 6
Heat-Duct-Pro 9
400 - 3~ / 50
9000
0 – 4500 - 9000
1227
IP24
H07RN-F 5G1,5mm²
150cm
5 pole – 16A
46 x 31,5 x 42
11,7
17