EUROM Heat-Duct-Pro 3 Manuel D'utilisation page 18

Masquer les pouces Voir aussi pour Heat-Duct-Pro 3:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 23
surfaces. Check the electrical cable and the plug regularly for damage and do not
use the device if you detect damage. First have it repaired.
7. If possible, do not use an extension cord, as this poses the risk of overheating
and fire. If the use of an extension cord is unavoidable, then make sure it is an
undamaged, approved extension cord with a minimum diameter of 2.5 mm²,
suitable for a minimum permissible power of 3500 Watt (HDP3) / 10.000 Watt
(HDP9). To prevent overheating, always fully extend the cord!
8. To prevent the circuit overloading and fuses being blown, make sure no other
appliances are connected to the same socket or wired to the same electrical
circuit as the heater.
9. Do not use the heater outdoors and do not use it in spaces smaller than 30m³
(HDP3) / 90 m³ (HDP9).
10. A heater contains hot and/or glowing and sparking components. Do not,
therefore, use in areas where fuels, paint, flammable liquids and/or gasses etc.
are stored.
11. Do not place the heater near, under or directly opposite a socket and do not place
it near an open fire or other heat source.
12. Do not use the heater near or directly opposite furniture, animals, curtains, paper,
clothes, bedding or other inflammable objects. Keep them at least 1 metre away
from the heater!
13. Never cover a heater! The heater's air inlets and outlets should never be
obstructed in any way, so as to prevent the possibility of fire. Never use the heater
to dry clothes and do not place anything on top of the heater. Do not place it on
soft surfaces such as beds or deep-pile carpets, as they can block openings.
14. Make sure that the air around the heater can circulate freely. Do not place the
heater too close to walls or large objects and do not place it under shelves,
cupboards, and similar.
15. Prevent foreign objects from entering the heater via the venting or exhaust
openings as this may lead to electric shock, fire or damage.
16. Never leave the heater unattended when switched on. Always switch if off before
removing the plug from the socket. Always unplug the heater when not in use! Pull
on the plug to remove from the socket, never pull on the cord.
17. Always switch the heater off, unplug it and leave to cool down before:
-
cleaning the heater
-
carrying out maintenance to the heater
-
touching or moving the heater. Use the handle for this!
18. This machine gets hot when it is in use. To prevent burns, do not let bare skin
come into contact with hot surfaces.
19. Do not use a timer or a similar product to automatically switch on the heater.
Always perform safety checks before using the heater!
20. Close supervision is necessary if the product is used near children or
incapacitated persons. This appliance is not suitable to be operated by children or
persons who have physical, sensory and/or mental limitations, or by persons who
have no knowledge of, or experience with, this appliance. This appliance can be
used by children aged from 8 years and above and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning use of the appliance in
a safe way and understand the hazards involved. Children shall not play with the
18

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Heat-duct-pro 9

Table des Matières