Permobil SpeedControl Instructions D'installation page 6

7. Rotate the arm to a position that is comfortable. If preferred,
lock the arm into position by tightening the outside screw,
using the 5mm hex wrench.
8. Place the SpeedControl device in the arm "pocket". Position
the device so you can see the LED from a seated position.
9. Secure the device to the arm with the M4 screw and the
provided 3mm hex wrench.
10. Route the cable through the slot on the arm.
11. Cable Routing Instructions:
a. Rigid Frame wheelchairs: Use the supplied hook and loop
fastener strips to secure the cable to the seat upholstery.
Route the cable on top of the seat upholstery, underneath
the cushion, and out the back of the wheelchair.
b. Folding Frame wheelchairs: Use the provided tie-straps to
route the cables along the frame tubes and out the rear of the
wheelchair.
Note: For routing examples, refer to page 109 for Rigid Frame
Wheelchairs and page 110 for Folding Frame Wheelchairs.
CAUTIONS:
- Check to make sure that the cable doesn't protrude from
the wheelchair, where it could get caught and be damaged.
- Avoid routing the cable on a folding frame wheelchair
where the folding mechanism could cut or stretch the cable.
EN - SpeedControl Installation Instructions
7
8
10
- 6
9