Permobil SpeedControl Instructions D'installation page 12

Magnetic Holder for Cable Connector
When the cable connector is not connected to the SmartDrive,
it can be secured to the wheelchair with the provided magnetic
holder. This magnetic holder is attached to the SmartDrive
adaptive axle clamp.
WARNING: Installing the magnetic holder will affect the
installation of the SmartDrive adaptive axle clamp. The
attachment, position and orientation of the clamp is critical to
the correct function of the SmartDrive. When performing the
steps below, read and follow the "Axle Clamp Mounting
Instructions" to ensure the SmartDrive functions safely and as
intended.
To install the magnetic holder:
1. Position the magnetic holder (A) between the front and back
parts of the adaptive axle clamp (B).
2. Feed the top clamp screw (C) through the hole in the holder,
and securely tighten.
3. Tighten the bottom clamp screw.
Note: To prevent rattle, tighten the top clamp screw first, and
then tighten the bottom clamp screw.
EN - SpeedControl Installation Instructions - 12
C
A
B