Permobil SpeedControl Instructions D'installation page 2

PART ONE: Select L/R switch position and rubber insert.
L/R switch selection:
The SpeedControl device is mounted to either the LEFT or
RIGHT side of the wheelchair frame, depending on which hand you will use to operate
the device. Before attaching the SpeedControl on the wheelchair, check to make sure that the
rubber L/R switch (located on the back of the device) is in the correct position. Switch to "R"
for right-hand use. Switch to "L" for left-hand use.
Rubber insert selection:
Before installation, select the correct rubber insert based on the
diameter of the wheelchair tube. Then follow the instructions in PART TWO.
Note: If needed, use the circumference to determine the diameter of the wheelchair tube.
Use a measuring tape, or cut out a strip of paper, and wrap it around the tube. Use the table
below.
circumference (approximate)
23/8 in (60mm)
23/4 in (70mm)
31/4 in (80mm)
31/2 in (89mm)
4 in (100mm)
45/16 in (110mm)
43/4 in (120mm)
If the wheelchair tube is not round, use the rubber insert that provides the most secure
installation.
Note about rubber insert placement for round tube applications (see PART TWO instructions):
During attachment, you will be placing the rubber insert in the clamp. For correct placement,
(A) will fit in the round opening of the clamp, and (B) will fit in the cutout.
EN - SpeedControl Installation Instructions
diameter
3/4 in (19mm)
7/8 in (22mm)
1 in (25mm)
11/8 in (28mm)
11/4 in (32mm)
13/8 in (35mm)
11/2 in (38mm)
- 2
rubber insert
#19
#22
#25
#28
#32
#35
#38
L/R switch
Rubber insert placement
(See PART TWO instructions.)
A
B