Changing The Preload Of The Shock; Rear Shock Kayaba (Factory); Changing The Shock Spring - Sherco 250 SEF/R Manuel Du Propriétaire

CHANGING THE PRELOAD OF THE SHOCK

REAR SHOCK KAYABA (FACTORY)

Remove and clean the rear shock unit (
Loosen the collar
1
Loosen / tighten the red plastic ring
Loosening
one turn
Indications
Tightening
one turn

CHANGING THE SHOCK SPRING

Remove and clean the rear shock unit (
Select and install a spring based on your weight.
Spring Rate
Rider Weight (with equipment) : 65-75kg
Rider Weight (with equipment) : 75-85kg
Rider Weight (with equipment) : 85-95kg
Reinstall the shock.
Adjust the sag ( p.96)
☛
Adjust the static deflection (
1
2
☛
.
depending on the length required..
2
Decreases the ove-
rall length by 4mm.
Increases the overall
length by 4mm.
☛
p.96)
☛
Remove and clean the rear shock unit (
Loosen the collar
Loosen / tighten the red plastic ring
ding on the length required.
Loosening
one turn
Indications
Tightening
one turn
Tighten the collar
Reinstall the shock (
Recheck the settings (
p.106).
Tighten the collar
5 Nm).
Reinstall the shock (
Recheck the settings (
p.106)
48N/mm
51N/mm
54N/mm
.
1
2
Decreases the ove-
rall length by 3mm.
Increases the overall
length by 3mm.
(tightening torque: 5 Nm)
1
p.107)
☛
p.96)
☛
(tightening torque:
1
p.107)
☛
p.96)
☛
p.106).
☛
depen-
97