Electrical System Maintenance; Removing The Battery - Sherco 250 SEF/R Manuel Du Propriétaire

250-300 SEF/R
Brakes (continued)
2

Electrical system maintenance

REMOVING THE BATTERY

2
116
1
1
3
Install the new pads.
Reinstall the retaining pins
Check the brake fluid level and fill if necessary.
( p.110 et p.112)
☛
ATTENTION
Do not use the bike until the brake lever and the pedal
are operational. «Pump» the brake lever / brake pedal
up and down until the brake pads are in contact with
the discs.
Turn off all electric devices and stop the engine.
CAUTION
Wait at least 30 secondes, bike turned off and stop-
ped, so that the Keyless system turns off
If this is not done there is a significant risk of
damage to the computer (ECU).
- Remove the seat (
☛
- Remove the air filter (
- The battery is located at the bottom of the filter
housing.
- Remove the two screws
battery retaining bracket.
- Disconnect the negative cable from the battery
- Disconnect the battery positive cable
- Remove the battery from the top.
and clips
2 1
p.98)
p.98).
☛
that retain the
1
.
3
.
2