Publicité
Les langues disponibles
Les langues disponibles
ADJUSTING THE COMPRESSION
DAMPER
The hydraulic compression damper deter-
mines the behaviour of the telescopic fork
during compression and can be adjusted
by means of screw B located at the lower
end of the fork legs. Turning the screw
clockwise increases the action of the com-
pression damper; turning it anticlockwise
decreases the action of the compression
damper.
For standard calibration, refer to page 12.
SHOCK ABSORBER
ADJUSTING THE REBOUND
DAMPER
Turn screw A to adjust the hydraulic re-
bound damper.
Turning the screw anticlockwise (out) de-
creases the damping effect.
For standard setting, refer to page 12.
ADJUSTING THE HYDRAULIC
COMPRESSION DAMPER (HIGH
AND LOW SPEEDS)
Adjustment for low compression speed:
•Using a screwdriver, loosen screw C
by turning it clockwise to increase the
hydraulic compression damper.
For standard setting, refer to page 12.
Adjustment for high compression speed:
•Turn knob D anticlockwise to decrease the
hydraulic compression damper.
For standard setting, refer to page 12.
C
D
WARNING:
Starting from the standard position, turn
the knob anticlockwise (with a closing
action), the center screw will have an
integral movement, then will rotate with
the knob.
For standard setting, refer to page 12.
45
B
A
3
EN
Publicité
