Télécharger Imprimer la page

CYBEX gold ATON G SWIVE Mode D'emploi page 61

Publicité

Les langues disponibles

Les langues disponibles

Installing and Removing the Infant Car Seat ONLY
Installing the Infant Car Seat With Lap Belt Only
4. Check the recline angle. Adjust the seat
angle until the WHITE LEVEL LINE
on the Infant Car Seat is level with the
ground. A tightly rolled towel or pool
noodle (pg. 30) may be placed under
the Infant Car Seat near the vehicle seat
back to adjust the angle.
5. Grab the Infant Car Seat at the Belt
Guides and pull from side to side and
front to back to make sure it is installed
correctly. The Infant Car Seat should
not move more than 2.5 cm (1 in) in any
direction.
If the Infant Car Seat moves too much,
tighten the vehicle belts more and
recheck. You may try a different vehicle
seat or installation method, or both.
r
r
t
t
FRONT OF VEHICLE
White line MUST be parallel to
ground when seat is installed in
vehicle without base
61

Publicité

loading