CYBEX gold ATON G SWIVE Mode D'emploi page 54

Installing and Removing the Infant Car Seat ONLY
Installing the Infant Car Seat With Lap/Shoulder Belts
3. Lift Shoulder Belt over Handle and
around Infant Car Seat. Slide Shoulder
Belt into the rear blue Shoulder Belt
Guide.
4. Lock your vehicle Lap/Shoulder Belt.
Refer to your vehicle owner's manual
for how your vehicle Lap and Shoulder
Belt locks.
In many vehicles, you can switch the
Shoulder Belt Retractor into locking
mode by pulling the Shoulder Belt out
all the way. Check the vehicle owner's
manual to see how your system locks.
To check if the vehicle belt is locked,
after you install the Infant Car Seat, pull
up firmly on the Lap Belt between the
Lap Belt Guides. The belt should remain
tight if the vehicle system is locked.
54
e e
r r