EN
Safety Cautions
(Observe these cautions for safety's sake.)
Read these "Safety Cautions" carefully before starting installation work. Install the product properly.
This manual uses various indications to ensure a proper, safe installation and to prevent injury to the customer,
injury to other people and damage to property.
The symbols should be interpreted as follows.
Caution
Improper use or installation of this product may result in injury or property damage.
This symbol is used to indicate no
tampering with this product.
Do not subject the toilet bowl to strong forces or impacts.
Otherwise, the toilet bowl may break causing injury or leaks that may damage property.
Do not excessively bend or twist the water supply hose.
Otherwise, the flexible water supply hose may break causing leaks that may damage property.
Prohibited
Do not remove the water supply filter with the water supply valve being open.
If the water supply valve is not closed, water may gush out causing leaks that may damage property.
Be sure to use the included or specified parts for installation work.
Otherwise, the product may not be installed properly.
Carry out the installation work according to this installation manual.
Required
Otherwise, damage caused by water leaks may occur.
2
This symbol is used to indicate a
required step in the use of this product.
Caution
EN
Precaution before installation
300±10 mm
Water supply 1/2" NPT
(11-13/16")
For water supply from the wall
300±10 mm
305±10 mm
(11-13/16")
(12")
Water supply 1/2" NPT
For water supply from the floor
PVC water drain pipe
Caution
The height of the water supply pipe should be within 0+5/-8 mm
from the floor/wall. The shutoff valve cover may tilt or float and
may not be attached.
•
Exercise care to ensure that metal objects (wristwatch bands, belt buckles, etc.) do not come into contact with the ceramic
during installation, transport, or cleaning.
Such objects could rub the surface of the ceramic and leave stripe marks.
•
Secure the space required for toilet installation and at the same time, check door opening/closing for possible interference.
•
The remote control signal reception may be degraded and the NEOREST unit may not respond to the remote control if
there are shelves or cabinets on the rear wall at a height of less than 1400 mm (55-1/8 ") from the floor.
(Shelves and storage cabinets should be more than 1400 mm (55-1/8 ") from the floor.)
•
Make sure before installation that the water supply source and water drain pipe are in the specified positions according to
the diagram. If it is not positioned properly, the product may not be able to be installed correctly.
•
For water supply, ensure that the minimum required water pressure (flowing) is 0.05 MPa at 10 L/min. (while maximum
water pressure is 0.75 MPa)
•
Turn on electricity and water supply to the product after completing all installation work.
●This flushing ring is used in the event of a power outage.
Do not use (pull) it during installation.
Doing so may cause water to continue to flow into the toilet bowl
during test operation.
Manual water supply cord
Do not use
(pull).
By pulling the manual water supply cord (orange) until it stops,
you can toggle the flow of water to the toilet bow on and off.
●Before installing the product, be sure to
completely wash out any dirt, sand, etc.
from inside the water supply pipe.
3