Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

3
Description
3.1
Overview of the product
3.2

Intended use

The product described is a hand-held cordless angle grinder. It is designed to be used for cutting and
grinding metals and mineral materials, and for wire brushing without use of water. It can be used only for dry
grinding / cutting.
The power tool may be used for cutting, slitting and grinding mineral materials only when equipped with
the corresponding guard (optional accessory).
A dust removal hood together with a suitable Hilti vacuum cleaner must be used for working on mineral
materials such as concrete or stone.
▶ Use only Hilti Li­ion batteries of the B 22 series with this product.
▶ Use only Hilti battery chargers of the C4/36 series for charging these batteries.
3.3
Items supplied
Angle grinder, side handle, standard guard, front cover, clamping flange, clamping nut, wrench, operating
instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
3.4
Temperature-dependent motor protection
The temperature-dependent motor protection system monitors current input and motor temperature and
thus prevents the power tool overheating.
If the motor is overloaded through application of excessive working pressure, the power tool's performance
drops noticeably or it may stall completely.
If the power tool stalls or slows significantly due to overloading, release the pressure applied to the tool and
then allow it to run under no load for approx. 30 seconds.
*2149239*
1
@
;
=
%
&
(
)
+
§
/
:
$
£
|
2149239
Guard release button
Spindle lockbutton
Air vents
Release button with additional function
(charge status display activation)
Battery
Switch-on interlock release button
On/off switch
Vibration-absorbing side handle
Spindle
Standard guard
Clamping flange
Cutting disc / grinding disc
Clamping nut
Kwik lock clamping nut (optional)
Wrench
English
7

Publicité

Table des Matières
loading

Table des Matières