Intended Use; Items Supplied - Hilti GX 3 Mode D'emploi

▶ Call a doctor if the person is unconscious. Bring the person into a well-ventilated area and place the
person in the stable recovery position (i.e. lying on the side). If the person is not breathing, administer
artificial respiration and, if necessary, supply oxygen.
▶ After eye contact with gas, rinse the open eyes thoroughly under running water for several minutes.
▶ After skin contact with gas, wash the contact area carefully with soap and warm water. Subsequently
apply a skin cream.
General instructions concerning personal safety
▶ Take care to adopt an ergonomic body position. Work from a safe stance and take care to stay in balance
at all times. This will allow you to control the setting tool better, even in unexpected situations.
▶ Keep other people away from the working area, especially children.
3 Description
3.1 Overview of the product
Fastener guide
@
Slider for fastener driving depth adjustment
;
and for releasing the fastener guide
RESET button
=
Inlet/outlet valve
%
Cooling air slots
&
Belt hook
(
Trigger
)
Grip
+

3.2 Intended use

The product described is a gas-actuated fastening tool ("fastening tool"). It is designed to drive suitable
fasteners into concrete, steel, sand-lime block, concrete-block masonry, rendered masonry and other
materials suitable for use of the direct fastening technique.
The fastening tool is for hand-held use or use with the pole tool extension (accessory) only.

3.3 Items supplied

Gas-actuated fastening tool with fastener guide, toolbox, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Center or online
at: www.hilti.group
3.4 Fastener guide
The fastener guide holds the studs or, respectively, guides the nails and, when the tool is fired, thus directs the
fasteners into the supporting material at the desired position. Application-specific fastener guides (IF or ME)
are available for the GX 3 and GX 3-ME fastening tools (see type identification plate for exact designation).
3.5 Fasteners
Two types of fastener can be driven by the fastening tool: nails and threaded studs. Additional fastening
components, which can be inserted in the fastener guide, are also available for various applications.
3.6 Slider for fastener driving depth adjustment and for releasing the fastener guide
The slider can be used to reduce the depth to which the fastener is driven. In the EJECT position, it releases
the fastener guide for removal.
Status
+
­
EJECT
Printed: 28.09.2017 | Doc-Nr: PUB / 5261697 / 000 / 01
1
§
/
:
∙
$
£
|
¡
Q
Meaning
•
•
•
Nail pusher
Magazine lockbutton
Support leg
Magazine
Type identification plate
Gas can status indicator
GAS button
Gas can compartment
Gas can compartment cover
Standard fastener driving depth
Reduced fastener driving depth
Fastener guide release
English 17