Intended Use - Hilti SD 4500-A22 Mode D'emploi

Masquer les pouces Voir aussi pour SD 4500-A22:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Electrical safety
▶ Before beginning work, check the working area for concealed electric
cables or gas and water pipes. External metal parts of the power tool may
give you an electric shock if you damage an electric cable accidentally.
Power tool use and care
▶ Immediately switch off the power tool if the accessory tool jams. The
power tool might twist off-line.
▶ Wait until the power tool stops completely before you lay it down.
2.4 Battery use and care
▶ Observe the special regulations and instructions applicable to the trans-
port, storage and use of Li-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them
to temperatures over 80 °C.
▶ Do not use or charge batteries that have suffered mechanical impact,
have been dropped from a height or show signs of damage. In this case,
always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. In this case, place the
product in a non-flammable location, well away from flammable materials,
where it can be kept under observation and allowed to cool down. In this
case, always contact your Hilti Service.
3
Description
3.1 Overview of the product
Chuck
@
Power tool / accessory inter-
;
face (snap-on connection)
Universal hook
=
Motor cooling air intake
%
Grip
&
Motor cooling air intake
(
Forward / reverse selector
)
switch with safety lock

3.2 Intended use

The product described is a hand-held cordless electric tool, equipped with
a clutch, for use in drywall installation work.
The power tool is designed for driving and removing screws in drywall
installation work. Drywall screws with a length of up to 55 mm and a
diameter of up to 4.2 mm can be used.
*2153708*
Printed: 15.07.2019 | Doc-Nr: PUB / 5295856 / 000 / 02
1
+
§
/
:
$
2153708
Control switch (with electronic
speed control)
Lockbutton for continuous
operation
Belt hook
Charge state and fault display
(Li-ion battery)
Battery release buttons
Depth gauge
English
7

Publicité

Table des Matières
loading

Table des Matières