Publicité
Les langues disponibles
Les langues disponibles
Faults History
Press the DOWN key. The "Fault History" displays up to ten
faults in memory. The order of the faults begins with "Last
Err", which is the most recent fault, and proceeds through
the ten most recent messages in reverse chronological
order.
Run time hours at the moment of the fault are displayed
at the end of the first line. The second line of the display
shows the "Fault" message. If there are no faults in the
history buffer, the second line reads "All Faults Clear."
Brownout Detect.
Last Err
Inlet Temp Fail
Brownout Detect.
Fault 9
Brownout
Brownout Detect.
Last Err
All Faults Clear
Figure 17. Fault History
Press the Service
key again to access the Advance
Service Menu.
Heat Pump Temperatures
The "In/Out Temp" screen indicates the water temperature
sensed in the inlet and at the outlet of the heater.
HPPH Temp
Brownout Detect.
In 68F, Out
Figure 18. Inlet and Outlet Temperature
Coil and Outdoor Temperature
Press the DOWN key. The "Coil Temp" screen indicates
the temperature sensed, displayed on the first line. The
second line displays the temperature sensed by the
outdoor sensor.
Brownout Detect.
Coil Temp
Outdoor
Figure 19. Coil and Outdoor Temperature
Solar Heater Temperature
(Heat/Cool Models Only)
Press the DOWN key. When enabled from "Installers
Menu", the "Solar Temperature" screen indicates the
temperature sensed with the solar heater sensor. The
"In" reading indicates the inlet of the solar heater. Solar
APPROVED
450
230V
241
230V
or
0
230V
78F
230V
47F
68F
230V
UNCONTROLLED DOCUMENT IF PRINTED
inlet temperature readings should come from a field-
supplied 10K temperature sensor. Solar "Out" displays the
temperature at the outlet of the solar heater. This reading
comes from the Heat pump inlet sensor. This screen is
only displayed if the option "Solar Heating" is enabled
from "Installers Menu". For more details about solar heater
integration refer to section 13 Installers menu on page
21.
Solar Temp
Brownout Detect.
In 61F, Out 68F
Figure 20. Solar Heater Temperature
Pump Status
Press the DOWN key. When enabled from "Installers
Menu", the "Pump Status" screen indicates current pump
mode and speed selection.
Pump control is compatible with Raypak Protégé Variable-
speed Pump and 4 digital outputs speed selector. By
default, "Pump Control" is disabled. See page 21 to
select and configure "Pump Control" option.
Brownout Detect.
Protégé Pump
Speed2
Pump Status
Brownout Detect.
Figure 21. Pump Status
230V
1500 RPM
230V
Speed 2
230V
15
Publicité
