Télécharger Imprimer la page

Ingersoll Rand 244A Manuel D'instructions page 2

Masquer les pouces Voir aussi pour 244A:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 5
All manuals and user guides at all-guides.com
Note the position of the reversing mechanism before oper-
ating the tool so as to be aware of the direction of rotation
when operating the throttle.
Use only impact sockets and accessories. Do not use hand
(chrome) sockets or accessories.
The use of other than genuine Ingersoll-Rand replacement parts may result in safety hazards, decreased tool
performance, and increased maintenance, and may invalidate all warranties.
Repairs should be made only by authorized trained personnel. Consult your nearest Ingersoll-Rand Authorized
Servicenter.
WARNING
Always wear eye protection
when operating or performing
maintenance on this tool.
SETTING THE POWER REGULATOR
Impact wrenches are not torque control devices. Fasten-
ers with specific torque requirements must be checked
with suitable torque measuring devices after installation
with an impact wrench.
Models 244A and 244A-2 Impact Wrenches incorporate
a power regulator into the reverse mechanism that allows
the operator to have either full power output in one direc-
tion and reduced power output in the other direction or
full power output in both directions. To adjust the power,
proceed as follows:
For full power in both directions, rotate the reverse
valve until the notch on each end of the reverse valve
aligns with the number 5 on each side of the housing.
The numbers 0 thru 5 on
he housing are only for
reference and DO NOT
denote a specific power
output. Zero (0) desig
nates the lowest power
utput
while
five
(5)
denotes the highest.
Using the Tool (Continued)
Periodically check the drive end of the tool to make cer-
tain that the socket retainer functions correctly, and that
sockets and drive ends are not excessively worn which
may allow the socket to come off when rotating.
Impact Wrenches are not torque wrenches. Connections
requiring specific torque must be checked with a torque
meter after fitting with an impact wrench.
WARNING SYMBOL IDENTIFICATION
WARNING
Read this manual before
operating tool.
AGENCY SYMBOL IDENTIFICATION
European Community Mark
Indicates compliance with
relevant CE directives.
ADJUSTMENTS
For reduced power in the forward direction and full
power in the reverse direction, push the reverse valve
inward on the right side of the tool and rotate the reverse
valve until the notch on the right side aligns with the
desired number on the right side. This provides reduced
power in forward but full power in reverse when the
reverse valve is pushed in the opposite direction.
See Dwg. TPD1248.
For reduced power in the reverse direction and full
power in the forward direction, push the reverse valve
inward on the left side of the tool and rotate the reverse
valve until the notch on the left side aligns with the
desired number on the left side. This provides full power
in forward but reduced power in reverse when the reverse
valve is pushed the opposite direction.
See Dwg. TPD1249.
(Dwg. TPD1247)
2
WARNING
Always wear hearing
protection when operating
this tool.
(Dwg. TPD1248)
(Dwg. TPD1249)

Publicité

loading

Ce manuel est également adapté pour:

244a-2