Worx WX523 Mode D'emploi page 14

HSS blade
TCT blade
Do not expose to rain or water
Do not burn
Positive terminal
Negative terminal
xINR18/65-y: Cylindrical lithium
Ion battery cells with max diameter
of 18mm and max height of 65mm;
"x" represents a number cells serial
connected, blank if 1; "-y" represents a
number of cells paralleled connected,
14
blank if 1.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE:
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece.
ASSEMBLY AND OPERATION
Action
BEFORE OPERATION
Removing the battery pack
Charging the battery
Installing the battery pack
ASSEMBLY
Saw blade Assembly and
Removing
WARNING: Always
remove the battery
before changing the blade!
Lithium-Ion Cordless Circular Saw
All manuals and user guides at all-guides.com
Safety On/Off Switch
sharp blade, please don't put
your hands around the Base
Plate.
Cross and Rip Cutting
Note: To avoid injury from
Kickback, please don't start
cutting until the blade runs
stably.
Cutting Depth Adjusting
Using the laser light feature
Replacing laser batteries
Parallel Guide
Pocket Cutting
Sawdust Removal
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes too hot, please run your
circular saw no load for 2-3 minutes to cool the motor.
Avoid prolonged usage at very low speeds.
Protect saw blades against impact and shock. Cutting with
extreme force can significantly reduces the performance
capability of the tool and reduces the service life of the
saw blade. Sawing performance and cutting quality
depend essentially on the condition and the tooth count
of the saw blade. Therefore, use only sharp saw blades
that are suited for the material being cut.
Choice of blades: 24 teeth for general work, approx.
40 teeth for finer cuts, more than 40 teeth for very fine
cuts into delicate surfaces, diamond for tile, cement
board, etc.
Only use saw blades recommended.
MAINTAIN TOOLS WITH
CARE
Figure
Remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
See Fig. A1
Keep tools sharp and clean for better and safer
See Fig. A2
performance. Follow instructions for lubricating and
changing accessories. Inspect tool cords periodically
See Fig. A3
and if damaged, have repaired by authorized service
facility. Your power tool requires no additional
lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water
or chemical cleaners to clean your power tool. Wipe
See Fig. B clean with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots clean.
Keep all working controls free of dust.
WARNING:To avoid
cutting injury from the
See Fig. C1, C2
See Fig. D1, D2
See Fig. E1, E2
See Fig. F
See Fig. G1-G3
See Fig. H1, H2
See Fig. I1, I2
See Fig. J
EN