Selco Saber 70 chp Manuel D'instructions page 40

4 Program cancellation
Select the required program by rotating the encoder.
Delete the selected program by pressing button (1)
.
Confirm the operation by pressing button (2)
Confirm the operation by pressing button (1)
Cancel the operation by pressing button (2)
3.8 Lock/unlock
Allows all the settings to be locked from the control panel with
a security password.
Enter set-up by pressing the encoder key for at least 5 seconds.
Select the required parameter (551).
Activate the regulation of the selected parameter by pressing the
encoder button.
Set a numerical code (password) by rotating the encoder.
Confirm the change made by pressing the encoder button.
40
All manuals and user guides at all-guides.com
Save and exit the current screen by pressing button (4)
The carrying out of any operation on a locked control panel
causes a special screen to appear.
-
.
-
3.9 Guard limits
Allows the cutting process to be controlled by setting warning
limits
main measurable parameters :
.
.
Enter set-up by pressing the encoder button for at least 5 seconds.
Select the required parameter (801).
Enter the "Guard limits" screen by pressing the encoder button.
Select the required parameter by pressing button (1)
Access the panel functionalities temporarily (5 minutes) by
rotating the encoder and entering the correct password.
Confirm the change made by pressing button/encoder.
Unlock the control panel definitively by entering set-up (fol-
low the instructions given above) and bring back parameter
551 to "off".
Confirm the changes made by pressing button (4)
Confirm the change made by pressing the encoder.
and guard limits
Cutting current
Cutting voltage
Air pressure
.
.
for the
.