Publicité
Les langues disponibles
Les langues disponibles
10
Check level side to side and
adjust legs if needed
Place level against top front opening of tub. Check that
dishwasher is level from side-to-side. If dishwasher is not level,
adjust front legs up or down until dishwasher is level.
Be sure rubber washer is properly seated in fitting. Slide the
34" fitting up to the valve and hand tighten to avoid cross-
threading. Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An additional
Ya to Y2 turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
20
Place paper towel under 90° elbow fitting. Turn on water supply
and check for leaks. If leak occurs, repeat previous step.
NOTE: Do not use Teflon® tape with compression fittings.
Black drain hose
connector
Drain hose stop
Place towel under drain hose to catch any water in drain hose.
Place the small green drain hose clamp onto the small end of
the drain hose. Push the new drain hose into the black drain
hose connector up to the drain hose stop.
Green clamp
Black drain hose
connector
.
Drain hose
Drain hose stop
Using pliers, squeeze open the small green drain hose clamp
and slide onto connector between stops.
Black drain hose
connector
After hose is connected, remove towel.
T®TEFLON
is a registered trademark of E.l. Du Pont De Nemours and Company.
Publicité
