Kenmore W10300754A Instructions D'installation page 10

NOTE: To avoid vibration during operation, route the water
supply line so that it does not touch the dishwasher base, frame
or motor.
Add 90° elbow fitting to the
water supply line
Connect the 48" compression fitting to the water supply line
prior to installing the unit into the cabinet opening. Attach such
that the 94" connection is facing upward as shown above.
Copper tubing only: Put the tubing into the 90° elbow fitting as
far as it will go (the copper tubing bends and kinks easily). Slide
the nut and ferrule forward and start the nut onto the elbow
threads.
Flexible braided connection: Secure nut to elbow using %" open
ended wrench or adjustable wrench.
NOTE: Do not use Teflon® tape with compression fittings.
install Drain Hose
IMPORTANT: Always use a new drain hose. Check local codes
to determine whether an air gap is required.
+®TEFLON is a registered trademark of E.l. Du Pont De Nemours and Company.
10
If needed, drill a 114" (3.8 cm) diameter hole in cabinet wall or
side of the opening closest to the sink.
Route drain hose
Drain hose
Cy
Route drain hose as shown through hole in cabinet to the front
center of opening where drain connection will be made. Tape
drain hose to the floor in area shown. This will prohibit it from
moving when dishwasher is moved into cabinet opening.
3 Connect drain hose
Connect drain hose to waste tee or waste disposer
using one of the following options:
* Option A, Waste disposer — no air gap
* Option B, No waste disposer—no air gap
« Option C,; Waste disposer — with air-gap
* Option D, No waste disposer — with air gap
IMPORTANT: The drain hose connection of the disposer or a
waste tee must be made before the drain trap and at least
20" (50.8 cm) above the floor where the dishwasher will be
installed.
Helpful Tip: To reduce vibration of the hose, keep the hose away
from the floor.