Publicité
Les langues disponibles
Les langues disponibles
NOTE: Springs should be in the same notches on left and right
sides.
Door falls open—
_
Increase spring tension
If the door falls open, increase the spring tension by moving the
spring end toward the back of the dishwasher.
NOTE: Springs should be in the same notches on left and right
sides.
Move dishwasher into
Insulation
blanket
IMPORTANT:
If wheels were removed, cover the floor when
moving the dishwasher to avoid damage to the floor. Slowly
move dishwasher completely into cabinet opening. Do not kink
or pinch water line, drain hose, power supply cord or direct wire
between dishwasher and cabinet. Remove cardboard from
under dishwasher.
NOTES:
g
It is all right if dishwasher fits tightly into cabinet opening.
Do not remove insulation blanket — the blanket reduces the
sound level.
m=
If using power cord, make sure to route end through hole in
cutout before sliding dishwasher into cabinet opening.
| 8] Align front of dishwasher
with front of cabinet doors
oN
Align front of dishwasher door panel with front of cabinet doors.
You may need to adjust alignment to be even with your
cabinets.
Check for plumb and
adjust legs if needed
Check that leveling legs are firmly against the floor. Close and
latch the door, and place level against the front panel. Check
that dishwasher is centered from front to back in the opening. If
needed, adjust leveling leg until dishwasher is plumb. Repeat for
other side of dishwasher.
Helpful Tip: Push up on front of dishwasher to raise dishwasher
off the ground to adjust front legs. With some installations, it
may be easier to adjust the front leg using the 46" hex head
socket or adjustable wrench.
Preferred method
Optional
method
19
Publicité
