Kenmore W10300754A Instructions D'installation page 24

Insulation
(on some models)
Check that grounding clip is attached to the lower panel.
Position the lower panel behind the access panel. On some
models there is insulation on the access panel that must fall
behind the insulation on the lower panel.
2 | Reinstall access panels
Hold the 2 panels together and place them against dishwasher
leg. Using a Phillips or 4" screwdriver, reinstall the screws
through the holes in the access panel and the slots in the lower
panel.
3
Check lower panel edge
XS
Check that the lower edge of the lower panel contacts the floor.
Adjust if necessary.
24
Tighten screws
Tighten access panel screws.
yr
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Power supply cord—Plug into
a grounded 3 prong outlet
Plug into a grounded 3 prong outlet. Check that power supply
cord does not touch dishwasher motor or lower part of
dishwasher tub.