Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
9) After balancing the door, hole covers are glued to the
empty holes and the holes are closed.
NOTE
Maximum weight of custom panel must not
exceed 13 lb (6 kg).
7 – 13 Ibs (3-6 Kg)
10)Mounting brackets previously fastened to the
dishwasher are also fastened to the cabinetry with
Screws
5/32" x 19/32" ( 4mm x 15mm).
11)Check whether the bottom of the door hits the toe kick of
the kitchen cabinet.
•
If the door hits the toe kick, cut the required section out
of the toe kick.
•
Apply silicone or sealant to the cut edge of the kitchen
cabinet toe kick or paint it so that it does not absorb
moisture.
22
4X
1 5/32"
(12 mm)
5/64"
(2 mm)
INSTALLER CHECKLIST
Your installer must have completed and checked the
following:
The dishwasher is square and level.
Fig. 28
The dishwasher is fastened securely to the
cabinetry.
The dishwasher door opens and closes freely. The
dishwasher door must close without hitting any
cabinetry or countertop.
The inlet water supply is turned on and checked
for leaks.
The drain hose has been connected and checked
for leaks. There must be no kinks or obstructions
in the drain hose.
The drain hose must be installed with a 30" (762
mm) high drain loop for drain hook-ups without any
air removed.
If you connect the water drain hose to a trap spigot
under the sink, remove the plastic membrane. If
you do not remove the entire membrane, leftover
food could cause a blockage in the drain hose
spigot. Ensure a hose clamp is used to secure the
hose to the spigot.
Fig. 29
The spray arms are free and rotate freely.
The rinse cycle has been run.
The water level will be below the filter screen after
the end of the wash program. It is normal to find
some water in the drain filter area.
FINAL INSTRUCTIONS
1) Press the On/Off button to turn the dishwasher on.
2) Power indicator light comes on.
3) Use the Program Select button to choose a washing
program.
Fig. 30
Publicité
