Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
IMPORTANT SAFETY INSTRUCTIONS
In addition to these instructions, the dishwasher shall be
installed:
•
In accordance with all local codes or, in the absence of a
local code:
•
In the United States, with the National Electric Code,
•
In Canada, with the Canadian Electric Code C22.1-latest
edition/Provincial and Municipal codes and/or local
codes.
When installing the dishwasher, follow basic precautions,
including the following:
•
Installation and repair should be performed by a
qualified installer. Work by unqualified persons could be
dangerous and may void the warranty.
NOTE
The dishwasher should be installed by
an insured licensed plumber, contractor,
or trained installer. Installation performed
by persons other than these could result
in improper installation and damage to
property.
•
Do
not
operate
malfunctioning, partially disassembled or if it has
missing or broken parts.
•
Before installation or service, disconnect the power
supply to the work area by unplugging the unit, "tripping"
the circuit breaker or removing the fuse.
•
Only connect the dishwasher to the power supply when
all installation and plumbing work is complete.
•
Never connect the ground wire to gas lines, or hot water
pipes, plumbing lines.
•
If the dishwasher is installed in a location that is
subjected to freezing temperatures (e.g., vacation home,
cabin, etc.), you must drain all water from the
dishwasher's interior. Water system breakdowns that
occur due to freezing water are not covered under
warranty.
•
The dishwasher must be secured to adjacent cabinetry
using the brackets provided. Failure to do so may cause
damage to property or bodily injury.
•
The dishwasher is intended for residential use only and
should not be used in commercial establishments.
NOTE
Do not use any extension cord or portable
outlet device to connect the dishwasher to
a power supply.
16
the
appliance
if
damaged,
WARNING
Danger of suffocation! Ensure that any
plastic wrappings, bags, small pieces, etc.,
are disposed of safely and kept out of the
reach of children.
PREPARATION FOR INSTALLING MOUNTING
BRACKETS
The mounting brackets in the plastic bag should be used
when the dishwasher is installed in the cabinetry. Use of
any parts other than mounting brackets may result in
damage to property or bodily injury.
NOTE
There shall be an opening through the
partition between the compartments that is
large enough for the attachment plug to
pass through. The longest dimension of the
opening shall not be more than 38.1 mm
(1.5")
NOTE
If the partition is in wood, the edges of the
cabinetry should be smooth and rounded,
or, if the partition is in metal, the edges of
the cabinetry should be covered with an
edge protector; when the appliance is
installed or removed, take care to reduce
the likelihood of damage to the power
supply cord.
1) Place the two mounting brackets into the top corners of
the dishwasher.
2) If necessary (depending on countertop board material),
bend the sides of the mounting brackets.
If countertop board material is wood, etc.;
Fig. 11
Publicité
