SAKAWA BS7001 Manuel De L'utilisateur page 143

Crankcase oil filling:
- Place the machine on a flat, horizontal and clear surface.
- Unscrew the oil filler cap. - Insert 0.6 l. of oil through the filling tube.
- Wait 1 minute for the oil to fully lower into the engine crankcase.
- Clean the dipstick of the oil cap with a cloth.
- Insert the dipstick and screw on the oil cap.
- Unscrew the cap again and check the mark that the oil has left on the dipstick. The signal left by the oil
must be between the minimum and maximum marks.
- If the mark is below the minimum add a little more oil and check again.
- If the mark is above the maximum you will have to remove oil from the crankcase. To do this, tilt the
machine and let some oil out (put a container at the end of the tube to prevent the oil from spilling on
the machine or the floor).
7.2.3. SPARK SKIP CHECK
The most common problems when starting a machine are caused by a dirty or spoiled spark plug. Clean
the spark plug and check it regularly. Verify that the distance between electrodes is correct (0.6 - 0.7
mm)
7.2.3. LUBRICATING THE OUTER BEARING
143