SAKAWA BS7001 Manuel De L'utilisateur page 141

7.1.2. OIL LEVEL CHECK
Place the machine on a flat, horizontal, uncluttered surface.
Unscrew the oil filler cap.
Clean the oil plug rod with a cloth
Insert the dipstick and screw on the oil stopper.
Unscrew the cap again and check the mark that the oil has left on the dipstick. The signal left by
the oil must be between the minimum and maximum marks.
If the mark is below the minimum add a little more oil and check again.
If the mark is above the maximum you will have to remove oil from the crankcase. To do this, tilt
the machine and let some oil out (put a container at the end of the tube to prevent the oil from
spilling on the machine or the floor).
7.2. PERIODIC MAINTENANCE
Perform regular inspections on the machine to ensure efficient operation of the machine.
For complete maintenance we recommend that you take the machine to your technical service.
Always use appropriate spare parts in order to obtain adequate product performance and avoid
damage and risks to machine and user. Spare parts must be purchased from the dealer's
technical service. The use of unofficial spare parts can cause risks of accident, personal injury to
the user and breakage of the machine.
Perform maintenance as often as shown in the following table:
Operation Before each
use
Check for X
loose parts
Check oil X
level
Change
engine oil
Clean air
filter
Greasing
bearings
Strap tension
Check spark
plug
7.2.1. AIR FILTER
Dirt on the air filter will cause a reduction in the machine's performance. Check and clean this
item. If you notice damage or alterations to the filter, replace it with a new one.
To clean the filter:
•Remove the protective cap from the filter.
•Remove the filter. - Clean the filter with soapy water.
•Rinse the filter with plenty of clean water.
After the first Every
hours of use hours of use
X X
X
X
X
141
25 Every 50 After the last
hours of use use
season
X
X
X
X
of the