SAKAWA BS7001 Manuel De L'utilisateur page 138

Pieces of firewood that get stuck transversely in the inlet hopper should only be removed when
the blades have stopped rotating. If the machine gets stuck, you need to turn it off and wait for
the blades to stop rotating
In case the engine is blocked by a piece of firewood:
- Disconnect the switch from the machine, remove the housing from the rotor shaft and turn the
rotor a few degrees with a wrench.
- Then, remove the piece in a transverse position with a stick or long-range object.
ATTENTION: NEVER PUT YOUR HANDS IN THE ROTOR.
Never leave the machine running or unattended. Stop the engine and remove the pipe from the
spark plug before replacing the blades or counterblade.
After one hour of operation check that all screws and nuts are tightened, otherwise tighten them.
Always use original parts, otherwise the warranty will lose its validity. The machine should only
be repaired by an authorized technical service.
5.4.2. ENGINE STARTING
Before starting the engine: Be sure to check the engine oil and fuel tank level
5.4.2.1 SC SYSTEM SECURITY SYSTEM
This machine has an automatic machine stop system in case it is pressed designed for
emergency stop in the event that the operator unintentionally inserts a hand into the hopper.
138