Publicité
Les langues disponibles
Les langues disponibles
12. Powercon socket
16. 3-Pin DMX in
13. Power Switch
17. 5-Pin DMX out
14. Fuse
18. 5-Pin DMX in
15. 3-Pin DMX out
Installation instructions
CAUTION !
Please consider the GB7000.15/EN60598-2-17
and the other respective national norms during the
installation. The installation must only be carried out by a
qualified person.
The applicable temperature for the Led Moving Head is between
0°C to 40°C. Do not use the Led Moving Head under or above
the temperature.
The installation of the effect has to be built and constructed in a
way that it can hold 10 times the weight for 1 hour without any
harming deformation.
The installation must always be secured with a secondary safety
attachment, e.g. an appropriate safety rope.
Never stand directly below the device when mounting, removing
or servicing the fixture.
The operator has to make sure the safety relating and machine
technical installations are approved by an expert before taking
the device into operation for the first time.
These installations have to be approved by a skilled person once
a year.
All manuals and user guides at all-guides.com
Before taking into operation for the first time, the installation
Cautions :
The effect should be installed outside areas where persons may
reach it, walk by or be seated.
Overhead mounting requires extensive experience, including
amongst others calculating working load limits, installation material
being used, and periodic safety inspection of all installation
material and the device. If you lack these qualifications, do not
attempt the installation yourself. Improper installation can result
in bodily injury.
Before mounting make sure that the installation area can hold a
minimum point load of 10 times the device's weight.
Connect the fixture to the mains with the power plug.
Installation method via clamp
Please refer to the picture below:
Fix the clamp on the bracket by tighten up the M12 screw on
the bracket to the M13 hole in the middle of the bracket.
Insert the quick-lock fasteners of the first Omega holder into the
respective holes on the bottom of the device. Tighten the quick-
lock fasteners fully clockwise.
Install the second Omega holder.
Pull the safety-rope through the holes on the bottom of the
base and over the trussing system or a safe fixation spot. Insert
the end in the carabiner and tighten the safety screw.
USER MANUAL
6
CAUTION !
has to be approved by an expert.
CAUTION !
The electric connection must only be carried
out by a qualified electrician.
Publicité
