Publicité
Les langues disponibles
Les langues disponibles
13
SAFETY
This section contains information and important notes on the safe commissioning and handling of the
machine.
For your safety, read this manual carefully before commissioning. This will enable you to
handle the machine safely and thus prevent misunderstandings as well as personal injury
and damage to property. Pay special attention to the symbols and pictograms used on the
machine as well as the safety information and danger warnings!
13.1 Intended use of the machine
The machinery is intended exclusively for the following activities: Sweep of paved areas and paths;
with mounted snow blade also for removing snow from private path in the specified limits.
ZIPPER MASCHINEN GmbH assumes no responsibility or warranty for any other use or
use beyond this and for any resulting damage to property or injury.
13.1.1
Technical restrictions
The machine is intended for use under the following ambient conditions:
Relative humidity:
Temperature (for operation):
Temperature (Storage, Transport):
Altitude above sea level
13.1.2
Prohibited Use / Hazardous misapplications
•
Operation of the machine without adequate physical and mental aptitude
•
Operating the machine without knowledge of the operating instructions
•
Changes in the design of the machine
•
Operating the machine under explosive conditions
•
Operating the machine outside the specified power range
•
Remove the safety markings attached to the machine.
•
Modify, circumvent or disable the safety devices of the machine.
The improper use or disregard of the versions and instructions described in this manual will result in the
voiding of all warranty and compensation claims against Zipper Maschinen GmbH.
13.2 User requirements
The machine is designed for operation by one person. The physical and mental aptitude as well as
knowledge and understanding of the operating instructions are prerequisites for operating the machine.
Persons who, because of their physical, sensory or mental abilities or their inexperience or ignorance, are
unable to operate the machinery safely must not use it without supervision or instruction from a responsible
person.
Please note that local laws and regulations may determine the minimum age of the operator and restrict the
use of this machine!
Work on electrical components or equipment may only be carried out by a qualified electrician or under the
instruction and supervision of a qualified electrician.
Put on your personal protective equipment before working on the machine.
13.3 General safety instructions
To avoid malfunctions, damage and health hazards when working with the machine, the following points
must be observed in addition to the general rules for safe working:
•
Check the machine for completeness and function before commissioning. Only use the
machine if the guards and other protective devices required for the work are in place, in
good working condition and correctly maintained.
•
Select a level, vibration-free, non-slip surface as the installation site.
ZIPPER MASCHINEN GmbH
www.Zipper-Maschinen.at
NOTICE
max. 50 %
+5° C to +40° C
-20° C to +50° C
up to 1.000 m
SAFETY
22
ZI-HS8TN
Publicité
