Costway TQ10103 Mode D'emploi page 5

Attach the Bucket │ 5
Right Arm
1. Insert the middle axle to make it pass through the hole in the middle of the
right arm, and make the stoppers of the middle axle fit into the groove on the
right arm.
2. Fit a Ø10 washer to the end of the middle axle from the outside of the right
arm.
3. Tighten a Ø8 lock nut to the end of the middle axle with a Ø8 socket wrench.
4. Pass the rotation axle through the hole at the end of the right arm.
5. Fit a Ø10 washer to the end of the rotation axle.
6. Tighten a Ø8 lock nut to the end of the rotation axle with a Ø8 socket wrench.
7-8. As shown, fit the bucket into the right arm, and then fix the bucket on the
right rocker arm with a Ø8 lock nut.
08
There are four stoppers
on the Middle Axle
Rotation Axle
without stopper
Attach the Left & Right Arm-1 │ 6
5
4
3
Remove the Ø10 washers and Ø8 lock nuts on the hexagonal axle on
both sides of the car head.
1. Attach the right arm to the hexagonal shaft on the right side of the vehicle
body,
2. Attach the left arm to the hexagonal shaft on the left side of the vehicle
body.Tip: The left and right arms must be assembled horizontally and
symmetrically. When assembling, insert the middle axle and rotation axle
into the corresponding holes of the left arm at the same time.
3. Fit a Ø10 washer on each end of the hexagonal axle.
4. Tighten a Ø8 lock nut to each end of the hexagonal axle with two socket
wrenches.
5. Insert the arm hubcaps to the both arms.
EN
1
2
3
4
5
09