Adjusting The Parking Brakes - Vermeiren Trigo S Manuel D'installation

EN
NL
Trigo S (stepless)
For the foldable footplate:
1. On the bottom of the footplate, loosen both M6 screws (30).
2. Turn the footplate until the desired angle is reached.
3. Firmly tighten both screws (30).
PL
CS
For the opening footplate:
1. On the main tube (31), loosen the M6 screws (32) on both sides of
the footplate.
2. Turn the footplate until the desired angle is reached.
3. Firmly retighten both screws (32).
3.2.10 Footplate depth (only for Trigo S, folding footplate)
1. Remove the four M5 screws (33) from the footplate.
2. Place the footplate forwards/backwards to the desired
depth (2 positions available).
3. Firmly retighten the M5 screws (33). Make sure that the
footplate is frimly secured.

3.2.11 Adjusting the parking brakes

Depending on the diameter of the rear wheels and their position, the brakes can be adjusted
accordingly. The following instructions apply to both the push-pull brakes and the sports brakes.
1. Release the brake, see user manual.
2. Loosen the two screws (34) connecting the brake to
the frame.
3. Slide the brake forwards/backwards in the slot until
the desired position.
4. Firmly retighten both screws.
5. Verify if the brake is working properly; the wheel is
blocked, but the brake can still be operated easily.
If this is not the case, repeat the steps above until
the brake is adjusted well.
6. Repeat for the second parking brake. Make sure
that both brakes are adjusted identically.
10
Trigo S, Trigo T
2021-04
Assembly and adjustments
30
31
32
33
34