Güde ECO WHEELER 1500 E Mode D'emploi page 31

Best work presumptions:
1. Grass should be dry completely!
Advantages:
a. Cutting tool chamber will not get
obstructed with wet grass and the
grass is blown back in the collecting
bag
2. Grass should not be longer than 15cm!
Advantages
a. The passage to collecting bag will
not get jammed.
b. The collecting bag will be filled up
and it won't be necessary to empty it
so often.
3. The cutting tool should be sharp at any time!
Advantages
a. The grass is not thrown but cut and
will retain nice colour.
The manufacturer shall not be held liable for any
damages if the generally valid regulations and
provisions contained herein are not observed.
Safety Instructions for First Putting in
Operation
Always take care of the screwed joints to see that they
are tightened and use only the parts included in the
delivery.
Make sure that the cutting height is set up at the
highest distance from the ground before the first
switching on to prevent any damage to the unit.
Procedure
Follow the order of assembly of the parts. Observe the
arrangement of parts to respective figures.
Operation
Cable pull relief Fig. 6
To avoid accidental unplugging the cable form the
switch/plug assembly, make sure the cable is correctly
fitted to the cable pull relief device.
Any electrical connections, such as extension
cable should be of approved waterproof design for
outdoor use.
Cutting height adjustment Fig. 7
The cutting height is adjusted by moving the lever
within a raster. Six various settings are possible:
•
Lever on the left means lower cutting height
•
Lever on the right means larger cutting height
When the motor is on, the unit should not be tilted,
only on the operator-reverse side, if necessary for
switching on.
Unit switch on/off Fig. 8
Push the button (1) and move the switching lever if
necessary with the button pressed. (2). The it is
possible to release the button.
All manuals and user guides at all-guides.com
31
After the switching lever is released, the button
will come back in it original position and switch
the unit off.
When the motor is on, the unit should not be
tilted, only on the operator-reverse side, if
necessary for switching on.
Operation Safety Precautions
•
Do not use the unit before you have read the
instruction manual.
•
Observe all the safety instruction contained
herein.
•
Be responsible to other persons.
•
Look out for the connection cable very carefully for
it not get caught or cut.
•
The machine is equipped with the cutting tools
brake that makes them stop within 3 seconds after
enabling the switch. Never, under no
circumstances attempt at stopping the cutting
tools or tilting the machine with the tools still
rotating. Wait until they come to a stop by
themselves.
•
If the cutting tools get in contact with a foreign
matter, the operating switch has to be put off
(disconnected from the mains) immediately. When
the cutting tools come to a stop, check the
machine for damage. Go on with the work
provided that the machine is unimpaired.
•
Walk, while working, do not run.
•
Always walk forward while working. Never pull the
machine backward. .
•
On a slope, always aerate crosswise, never
upward and downward. A special attention should
taken to changing direction.
•
The cutting tools should not be in operation when
crossing areas not overgrown with grass and
when approaching and leaving the work site.
Always use the machine connected to the mains
via protection automatic switch (FI)!
Step by Step Instructions
1. Put the mower on the lawn where grass as short
as possible for the mower to start up easily.
Within the area to be cut, there should be no
stones and clods. They could be thrown off and
cause severe injuries.
2. Fit in the grass collecting bag according to chapter
Assembly and Initial Operation
3. Set the cutting height (chapter Operation)
according the grass length
4. Hang the cable in the pull relief device (chapter
Operation).
5. Plug the unit and switch it on according to
description.
6. Move the unit slowly and evenly on the grass. If
the motor gets too loaded, adjust the cutting
height and mow by stages.
7.
If there is much grass left on the ground, empty
the collecting bag.
GB