Konica Minolta Bizhub 362 Manuel D'installation page 6

11. Reinstall the toner supply port.
Note:
Make sure of the correct mounting position and
direction.
12. Reinstall the developing unit cover, ensuring
that its tabs are fitted properly into the slits
(three screws).
Tighten this screw first
All manuals and user guides at all-guides.com
13. Align the shaft of the developing unit with the
inner guide of the PC drum unit.
14. Slide the PC drum unit along the guide to check
that the positioning pin is properly aligned with
the mating hole.
15. Screw the PC drum unit in position (two silver
screws each on the right and left sides).
Note:
Use care not to touch or scratch the PC drum.
Positioning pin
A11UIXC018MA
Note:
Do not install the imaging unit (IU) into the
machine. imaging unit (IU) is installed at the ATDC
adjustment.
VIII. Plugging in CSRC Modem Cable
Note:
•
A11UIXC019MA
•
1. Insert the CSRC modem cable to the machine.
2. Mount the ferrite core to the cable, and mount the
banding band under the ferrite core.
Note:
Mount the ferrite core within 50 mm from the con-
nector.
E-6
Guide
Shaft
This step may not be performed depending on
the applicable marketing area.
Step 1 and 2 are necessary only when con-
ducting remote diagnosis by CSRC using the
phone line modem.
Guide
Shaft
4030U016AD
4040IXC144DA